Pasted Graphic Remedial Work
Installation testing is only part of the electrical safety compliance requirement. If the essential that remedial work is completed following testing to ensure due diligence.

When electrical safety testing is completed any ‘damage, deterioration, defects and dangerous conditions within the installation’ will be reported as follows:
  • Code 1 - requires urgent attention
  • Code 2 - potentially dangerous and should be given urgent attention
  • Code 3 - improvement recommended
  • Any fault reported as code 1 or 2 must be remedied
Essential remedial work must be completed in an appropriate timeframe, and in the case of many faults this means urgently following testing, so that the non-conformity is closed. HMC keep a standard stock within the company vehicles to assist in the first time fix policy throughout the organisation.

All required remedial works identified whilst testing will be detailed within our reports. Sign off sheets are issued to provide a formal closure of defects which enables traceability to each defect.

This provides our clients with a clear audit trail to prove compliance.
Stacks Image 2320
Stacks Image 116
Stacks Image p19534_n3
Stacks Image p19534_n5
NICEIC Approved Contractor
ISO 9001, 14001, 18001 Accredited
SafeContractor Approved
Fully qualified engineers
Engineering led approach
Sensible free advice
Efficient testing & Reporting
Online certification
Tracking system
HMC Compliance Ltd
Unit 3 Crowhurst Hop Farm Bullen Lane East Peckham Tonbridge Kent TN12 5LP
Tel: 0333 800 9909
Fax: 01622 870 077
Email: ObscureMyEmail